Serial messages are not supported by Ozone.For information about how to we recommend to contact Arduino support. We recommend to disable them if possible. Keep in mind that some debug features do not work or only in a limited fashion when sleep modes are active. On most Arduino platforms a sleep mode will be active.It is recommended to disable code optimization in the compiler. Per default the Arduino IDE will create optimized code which is missing crucial debug information for all debug features of Ozone to work.If everything worked out correctly the green LED next to the USB-C port should blink. To continue execution simply press F5 again.Per default the debugger will halt at main. The Ozone project is created and you can debug your application.For more information on why this is necessary see here. This is important, otherwise the Arduino bootloader will not be executed and the sketch execution will fail or behave unexpected. Now for both settings Initial PC and stack pointer select "Do not set".In this example it is path C:\Users\Nino\AppData\Local\Temp\arduino_build_695820\ Now press the three dots and navigate to the elf file which was created by the Arduino IDE earlier.Set host interface to USB and target interface to SWD.Select the STM32H747XI_M7 as target device.The red rectangle shows the path where the resulting elf file is located.Scroll to the bottom of the console, there you should find an output as follows. For this the verbose console output comes in handy.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |